It might be due to the fact that the chain cuts at an angle. Uneven wear of the guide bar leads to the chain rotating at an angle rather than aligning with the bar, creating a vicious circle of wear.
Why does my chainsaw cut to one side when I cut?
It can be hard to cut straight when the chainsaw pulls to one side. If the chain is dull or damaged, you need to make sure the chain is properly sharpened. The correct chainsaw chain is needed if you want to replace it.
How many times can a chainsaw chain be sharpened?
A chainsaw chain can be changed up to 10 times before it needs to be replaced. It depends on two things; the amount of wear on your chain and the amount of metal taken out every time you sharpen. The impact on the chainsaw chain can be different from material to material.
What happens if chainsaw is too loose?
Chainsaw chains start to droop on a saw’s guide bar during normal operations. If a chainsaw chain is allowed to get too loose, it can easily come off the bar and cause an unsafe situation for the user. Chainsaw chain tension should be checked on a regular basis.
Should you cut up or down with a chainsaw?
If you want to cut up from the bottom, you have to make a cut from the top. Sometimes a saw gets pinched in a down cut. One way to deal with this is to cut the log in half.
Is it better to cut wood wet or dry with a chainsaw?
It is possible that it will come as an eye-opener for some. It’s a lot easier to cut wet wood than it is dry wood. As the chainsaw chain comes into contact with the wood fibers, there is more of a feel to it. The chain slows down as a result of thisfriction.
What is the best chainsaw technique?
The first thing to do is to hold the front handle with your thumb. Make the first cut with the chainsaw by running it at full speed. Stand away from the chainsaw at a diagonal angle as you work. If you stand directly behind the chainsaw, there is a risk of injury from kickback.
Why does my chainsaw keep going blunt?
It could be a few things if your chain is dulled quickly. Make sure to check your user’s manual for the right size file. If you apply too much pressure when you file, it could be a problem. It will cause cutting edges to be too thin and dull.